Access Programming Mode

• 1). Turn the vehicle's ignition on and then turn the ignition off in order to access the programming mode.
  
  
• 2). Press and release the "Valet Switch" five times within five seconds. The siren will then sound or "chirp" briefly and the status light will flash to confirm that the system is entering Programming Mode.
  
  
• 3). Reset a feature.
  
  

Accessing and Resetting a Feature

• 1). Press and release the "Valet Switch" the same amount of times it takes to reach the desired feature's number. The siren will chirp and the status light will flash as many times as the "Valet Switch" was pressed to indicate the feature that is now accessed.
  
  
• 2). Cease pressing the "Valet Switch" once you find the feature you wish to reset. If you pass the feature you wish to reset, either continue pressing through features or wait 10 seconds and start from Step 2 of Section 1.
  
  
• 3). Press the "Disarm/ Unlock" or the "Arm/ Lock" buttons until settings are restored to factory set up.
  
  The features at factory settings are:
  
  Feature 1) Secure Code: 1 press
  
  Feature 2) 30/ 60 Second Alarm Duration: 60 seconds
  
  Feature 3) 3/ 45 Second Arming Delay: 3 seconds
  
  Feature 4) Last Door Arming: off
  
  Feature 5) Automatic Re-arming: off
  
  Feature 6) Auxiliary Output #2 Also Disarms System: on
  
  Feature 7) Parking Light Illumination Upon Disarm: on
  
  Feature 8) Doors Lock When Ignition is Turned On: on
  
  Feature 9) Unlock #1 When Ignition is Turned Off: on
  
  Feature 10) Unlock #2 When Ignition is Turned Off: off
  
  Feature 11) Open Door Bypass of Ignition Locking: on
  
  Feature 12) Doors Lock With Last Door Arming: off
  
  Feature 13) Doors Lock With Automatic Re-arm: off
  
  Feature 14) Ignition Activated Vehicle Recovery: off
  
  Feature 15) Door Activated Vehicle Recovery: off
  
  Feature 16) Remote Activated Vehicle Recovery: off
  
  Feature 17) Chirp Confirmation: on
  
  Feature 18) Remote Start Run Time 10/ 20 Minutes: 10 minutes
  
  Feature 19) Steady/ Flashing Lights During Remote Start: steady
  
  Feature 20) Remote Start Pre-activation: off
  
  Feature 21) Steady Siren/ Pulsed Horn Output: steady siren
  
  Feature 22) Soft/ Loud Horn Confirmation Chirps: medium low
  
  Feature 23) 1/2 Button Arming or Disarming: 2 button operation
  
  Feature 24) Door Lock/ Unlock Pulse Duration: 0.8 second
  
  Feature 25) Double Unlock Pulse: off
  
  Feature 26) Total Closure Lock Output: off
  
  Feature 27) Gasoline/ Diesel Engine: gasoline
  
  Feature 28) Extended Starter Cranking Time: minimum
  
  Feature 29) "Tach Wire" or "Tachless" Starter Operation: "tachless"
  
  Feature 30) Stick Shift Remote Starting: "tachless"
  
  Feature 31) Turbo Timer: off