- 1). Disconnect power from the Andis T-Blade by turning the clippers off and unplugging the unit.
- 2). Use a Phillips head screwdriver to remove the two screws holding the blades onto the clippers. Place the screws in a safe place as you will need them when putting the new blades on.
- 3). Remove the old blades from your Andis T-Blade by pulling them off gently.
- 4). Take the new blades and put them directly where the old blades were located, making sure to line up the screw holes on the blades with those on the clippers.
- 5). Put the screws that you saved from Step 2 into the screw holes and tighten using the same Phillips head screwdriver as before. Tighten until firm, but do not force them.
previous post
next post