- 1). Remove the red pipette from the side of the can by peeling away the piece of tape tha holds it to the can. Insert the red pipette into the center of the nozzle of the trigger sprayer on top of your can of Dynex Compressed Gas.
- 2). Hold the can straight or at a slight angle and point the end of the pipette as close as possible to the surface to be dusted.
- 3). Pull the trigger toward you with your index finger to release the compressed gas and dislodge the dust particles from the surface you are dusting. Move the can of air across the surface as necessary so that the force of the air penetrates all parts of the surface that need to be dusted.
- 4). Brush away any dislodged dust with a soft brush, such as a camera lens brush, if necessary.
- 5). Repeat Steps 3 and 4 if you see any remaining dust or if you need to clean another part of the surface.
- 6). Remove the pipette from the nozzle and affix it to the can of Dynex Compressed Air with a rubber band or tape for storage.
previous post