- 1). Clean the area where you will be storing the ATV trailer. Remove anything that might touch the rubber tires.
- 2). Raise the ATV trailer one side at a time using the jack and place a 2-by-2 wooden block under each trailer tire. Place chock blocks in front and behind each tire to keep the tires from rolling off of the wooden blocks. Remove the jack from under the trailer.
- 3). Wind the brake wire around your hand, making an "O" shape. Place the brake wire on the top of the trailer arm. Secure the brake wire to the top of the trailer arm using the rubber band.
- 4). Place the plastic bag over the trailer arm making sure that the bag completely covers the wiring and connector. Seal the opening of the plastic bag using the duct tape.
previous post