- 1). Unplug the unit from the wall.
- 2). Remove the trim on the top of the washer by removing the three screws.
- 3). Remove the three screws at the rear of the unit, at the top. Remove the top of the unit.
- 4). Pull out the soap dispenser.
- 5). Remove the four screws on the top and the one screw behind the control panel. Push in the clips of the control panel in on the sides and pull the control panel out.
- 6). Pull the bottom panel off the unit.
- 7). Open the door of the washer. Remove the three screws from the hinge. Pull the door off but do not disconnect the wires.
- 8). Slip the boot of the machine out from the hoses in the machine. Remove the bottom balance weight.
- 9). Loosen the screw clamp that holds the gasket in place. Replace with the new gasket, aligning the notch so the line on the gasket points up towards the ceiling.
- 10
Reassemble the unit reversing the take apart instructions.