- 1). Using a Phillips screwdriver, remove the panhead bolt that secures the headlight trim ring to the headlight shell. Lift the bottom of the trim ring upwards until it releases from the catch tab on the upper lip of the headlight shell.
- 2). Pull the headlamp assembly out of the headlight shell. Pull the rubber dust boot off of the rear of the headlamp assembly to reveal the headlight bulb.
- 3). Disconnect the wiring harness from the back of the bulb. Squeeze the sides of the bulb retaining pin together and swing it outwards to release the bulb. Discard the old headlight bulb.
- 4). Insert a new headlight bulb into the headlamp assembly and lock it into place with the retaining pin. Reconnect the wiring harness and replace the dust boot.
- 5). Slide the headlamp assembly into the headlight shell. Affix the top of the trim ring to the catch tab on the top of the headlight shell and lower it into place. Insert and tighten the panhead screw with a Phillips screwdriver to secure the trim ring.
previous post
next post